Mitsubishi Electric MA-E100R-E Service Manual page 32

(3) Removing the Case R, Case L, and Rear Case
1 Remove the inlet panel and two pre-
filters.
→ (See "(1) Removing the Inlet
Panel and Two Pre-filters".)
2 Remove the HEPA filter and two
activated charcoal filters.
→ (See "(2) Removing and
Replacing the HEPA Filter and Two
Activated Charcoal Filters".)
3 Remove the four case R/case L
mounting screws from the front of the
main unit, peel off the screw cover
sticker in each handle of the case R
and case L, and then remove the two
case R/case L mounting screws.
Case R
handle
4 Disengage the front joint of the case
L, and disengage the two lower
joints. Then, disengage the eight
remaining joints while opening the
case L from the front of the main unit.
Remove the joints of the case R via
the same procedure.
→ (Removing the Case R and Case
L)
5 Remove the six rear case mounting
screws from the rear of the main unit,
and then remove the rear case from
the six tabs.
→ (Removing the Rear Case)
Case R
mounting
screw
3
Screw cover sticker
Case R mounting screw
Front joint (1 place)
Case L
(symmetrical
to case R)
3
3
3
Case L
4
Bottom joint (2 places)
Rear case
Rear case
mounting
screw
32
Case R
3
Case L
mounting
screw
3
Screw cover sticker
Case L mounting screw
Joint
(11 places in total)
Tab
5
Tab
Case L
Case L
handle
Rear case
mounting
screw