Table of Contents
Advertisement
Troubleshooting
If the vacuum-mop encounters an error during operation, the power indicator will blink orange and you will hear a voice alert. To check for a solution,
please refer to the table below.
Fault
Error 1: Please clean and gently tap the bumper.
Error 2: Please place the vacuum-mop on the level
ground and reactivate it.
Error 3: Please clean the cliff sensor, place the vacuum
on level ground, and reactivate it.
Error 4: Please remove the brush and clean the bristles
and bearings.
Error 5: Please remove and clean the side brush.
Error 6: Please check whether any objects are wrapped
around the main wheels, then move the vacuum-mop
to a new location and reactivate it.
Error 7: Please clear any obstacles around the
vacuum-mop.
Error 8: Please reinstall the dust compartment and filter.
17
Solution
If the collision buffer is stuck, gently tap it to remove foreign objects. If it does
not work, move the vacuum-mop to a new area and reactivate it.
A wheel is off the ground. Place the vacuum-mop on the level ground and
reactivate it.
Part of the vacuum is off the ground. Place the vacuum on level ground and
reactivate it. This error may also occur if the cliff sensor is dirty. To rule out this
possibility, clean the cliff sensor.
A foreign object might be caught in the brush. Remove the brush and clean its
bristles and bearings.
A foreign object might be caught in the side brush. Remove the side brush and
clean it.
A foreign object might be caught in one of the main wheels. Clean the wheels,
then reactivate the vacuum-mop.
The vacuum-mop may be caught or stuck. Clear away any obstructions around it.
Make sure the dust compartment and filter are installed correctly. If the error
persists, try replacing the filter.
Error 9: Strong magnetic field detected. Reactivate the
vacuum-mop away from any virtual walls.
Error 10: Charging error. Try cleaning the charging
contacts.
Error 11: Please wait until the ba ery temperature
returns to normal, then resume use.
Error 12: A restricted area or virtual wall was detected.
Move the vacuum-mop away from this area.
Error 13: Please clean the visual navigation sensor.
Error 14: Internal error. Try rese ing the system.
If the problem still persists, please contact a er-sales service for assistance.
The vacuum-mop is too close to a virtual wall. Move the vacuum-mop to a new
location, then reactivate it.
Wipe the charging contacts on both the dock and the vacuum-mop with a dry
cloth.
The temperature of the ba ery is too high or too low. Wait for the temperature
to return to normal, then resume use.
Move the vacuum-mop away from the area with barrier tape, then reactivate it.
Wipe the visual navigation sensor, then reactivate the vacuum-mop.
The vacuum-mop cannot continue to operate due to an internal error. Try
rese ing the system.
18
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Mi Robot Vacuum-Mop and is the answer not in the manual?
Questions and answers
When can I switch off power of my Xiaomi mop
You should turn off the power of your Xiaomi Mi Robot Vacuum-Mop if it stops responding or cannot be turned off normally. To do this, press and hold the button for 6 seconds to forcefully turn it off.
This answer is automatically generated