Mitsubishi Electric M Series Manual page 52

Switch B
SW502-6
S W 5 0 2 7 -
1. CONTROLS
SW502-8
1-4. System Control Interface [MAC-333IF-E], cont.
4. Parts
Interface unit
[with connecting cable (5-core)]
Screws for mounting
3.5×12
Cushioning material
(with adhesive)
Mounting cord clamps
(small)
M-NET communication
cable
Remote control cable
(for connecting the
ME Remote Controller)
Remote control cable
(for connecting the MA
Remote Controller)
Signal cable (also used
as extension cable)
Related parts sold separately
Due to continuing improvement, above specification may be subject to change without notice.
52
contact point
prohibited
Behavior when prohibition
State before canceling prohibition of
of operation by contact
operation by contact point
point is canceled
N t o n i u s e — S ( t e o t
Setting when P series is
mixed in the same group
(only when running group N o m x i u t
operation using the MA
remote controller)
Mounting cord clamps
1
(medium)
Mounting cord clamps
2
(large)
Screws for mounting 3.5 × 12
1 and (Use when attaching the
clamps to the interface unit)
2 Cable ties
Item to be Prepare at the Installation Site
2-core shield cables CVVS/CPEVS,1.25mm
• When cross-wired by same terminal box, 1.25mm
CPEVS: PE insulated PVC jacketed shielded communication cable
CVVS: PVC insulated PVC jacketed shielded control cable
PE: Polyethylene PVC: Polyvinyl chloride
2-core shield cables CVVS/CPEVS*
• When the distance from the interface unit
• When the distance from the interface unit
2
2-core sheath cable 0.3mm to 1.25mm
Sheath cable 0.3mm 2 [AWG22] or more.*
• When remote control: The extension cable of Lead wires
• When status signal output: The cable for relay connection, or cable for DC power
Prepare the necessary number of parts sold separately as needed for your system.
* Please use cable with supplementary insulation.
Use wires which have insulation more than the MAX voltage.
MAX voltage is defined according to the law of the country where the interface is used.
M-Series - Controls (December 2016)
Running air conditioner
O F ) F —
e r M x i
Accessory
4
3
,
4
9
2
[AWG16] or more.*
2
[AWG16] is used.
is less than 10m: 0.3mm
is not less than 10m: 1.25mm
2
* [AWG22 to 16]*
e d
Fasteners (for joining the
wires)
Lead wires (3-core)
Screws for mounting
4 × 10 (Use when fixing
near the room air conditioner)
Screws for mounting
4 x 16 (Use when joining
room air conditioner parts)
2
[33ft: AWG22] or more.*
2
[33ft: AWG16] or more.*
© 2016 Mitsubishi Electric US, Inc.
5
1
1
1