Mitsubishi Electric M Series Manual page 42

1. CONTROLS
1-3. Simple MA Remote Controller [PAC-YT53CRAU], cont.
Mode No. selection
Select the mode No. you want to set with the
settable mode numbers can be selected.)
Mode No. display
Select the setting contents of the selected mode.
When the [ FAN] button is pressed, the current setting No. flashes. Use this to check the
currently set contents.
Select the setting No. using the
Setting No. display
Setting No. 1 =
Average temperature
reading of the indoor
units in operation
The contents set at steps
When the A [ON/OFF] button is pressed, the mode No. and setting No. flash and registration
begins. The flashing mode No. and setting No. change to a steady light and setting ends.
* When " " flashes at the Mode No. display, communication is probably abnormal.
Make sure there are no noise sources near the transmission line.
-------------------------------------------------------------------------------------------------------------------------------------
To select more functions, press the
-------------------------------------------------------------------------------------------------------------------------------------
End function selection.
Press and hold down the
or longer.
After a while, the function selection display disappears and the remote controller returns to the air
conditioner off display.
* Do not operate the air conditioner from the remote controller for 30 seconds after the end of
function selection.
NOTE: When the functions of an indoor unit were changed by function selection after the end
of installation, always indicate the set contents by entering check marks or other marks
in the appropriate check field of Table 1.
Due to continuing improvement, above specification may be subject to change without notice.
42
Mode No. 02 = Thermistor selection
[TEMP.
to are registered.
[ FAN] and repeat steps
[TEMP. ] and
M-Series - Controls (December 2016)
[TEMP. ] and [TEMP.
] and [TEMP. ] buttons.
to
[ FAN] buttons at the same time for two seconds
] buttons. (Only the
Setting No. 3 =
Built-in sensor on the
remote controller
.
© 2016 Mitsubishi Electric US, Inc.