Installing The Contactor - Toro Groundsmaster 5900 Installation Instructions Manual

5

Installing the Contactor

Parts needed for this procedure:
1 Contactor
1 Contactor mount
1 Cable
4 Nut (1/4 inch)
2 Nut (5/16 inch)
2 Flange bolt
2 Carriage bolt
Procedure
1. Use 2 carriage bolts and 2 nuts (1/4 inch) to
secure the contactor mount to the bracket
(Figure 7).
1. Carriage bolt
2. Contactor mount
2. Use 2 flange bolts and 2 nuts (1/4 inch) to secure
the contactor to the contactor mount
Figure 7
3. Nut (1/4 inch)
(Figure
1. Contactor
2. Flange bolt
3. Use a nut (5/16 inch) to secure the end of the
cable with the boot attached to the contactor
(Figure 9).
g282536
1. Nut (5/16 inch)
2. Cable
8).
4. Use a nut (5/16 inch) to secure the other end
of the cable to the right post of the fuse holder
(Figure 9).
5. Install the wire connector labeled
M C
ASTER
the contactor
4
Figure 8
3. Nut (1/4 inch)
Figure 9
3. Nut (5/16 inch)
] to the left post at the top of
ONTACTOR
(Figure 10).
g282537
g282535
+ [28
COIL V