Table of Contents
Advertisement
1 a
Side view (open terminal drawn for illustration)
1 b
The top view shows the openings for wire and screwdriver
2
Insert screwdriver (2.5 x 0.4 to 3.5 x 0.5 mm) at an angle, screwdriver must be at least 15
mm free of insulation at the tip
3 a
While erecting the screwdriver, insert it until the stop (requires a little strength)
3 b
Screwdriver inserted, terminal open
4
Strip the wire for 7 mm (and put on wire end ferrule)
5
Insert wire into the open terminal
6
Remove the screwdriver
7
Done
Disconnect wire from the spring terminal
1
Figure: Disconnect wire from the spring terminal (steps 1 to 3)
Conductor
4
Figure: Disconnect wire from the spring terminal (steps 4 to 6)
____________________________________________________________________________________________________________
V2
AC500 Hardware
Screwdriver
2
Screwdriver
5
1-28
Screwdriver
3
6
System data
AC500 / Issued: 05.2007
Advertisement
Table of Contents
