Install A Processor-Heat-Sink Module - Lenovo ThinkSystem SR550 Setup Manual

CAUTION:
Hazardous moving fan blades nearby. Keep fingers and other body parts away.
If there is a RAID super capacitor module installed on the top of the air baffle, remove the RAID super
capacitor module first.
To remove the air baffle, complete the following step:
Watch the procedure. A video of the removal process is available:
• YouTube:
https://www.youtube.com/playlist?list=PLYV5R7hVcs-C9jFjZnXQ6AmTXaIdX6_HJ
• Youku:
http://list.youku.com/albumlist/show/id_50429987
Figure 30. Air baffle removal
Step 1. Grasp the air baffle and carefully lift it out of the server.
After removing the air baffle, begin installing any options that you have purchased.

Install a processor-heat-sink module

This task has instructions for installing an assembled processor and heat sink, known as a processor-heat-
sink module (PHM), a processor, and a heat sink. All of these tasks require a Torx T30 driver.
Note: If you are installing multiple options relating to the system board, the PHM installation should be
performed first.
"Read the "Power off "ATTENTION:
installation the server
Static Sensitive Device
Guidelines" on for this task"
Ground package before opening"
page 46 on page 90 on page 48
.
Chapter 3 Server hardware setup
53