Table of Contents
Advertisement
GE
Sensing
We,
declare under our sole responsibility that the
Models T3, T5, T8, T11, T14 and T17 Wetted Ultrasonic Flow Transducers
Series BWT1 / F...PA / XAMP... Ultrasonic Flowmeter Transducer Assembly
to which this declaration relates, are in conformity with the following standards:
• EN 60079-0: 2012
• EN 60079-1: 2007
• II 2 G Ex d IIC T6...615°C Gb T3: KEMA06ATEX0052,
• EN 61326-1: 2006, Class A, Table 2, Industrial Locations
• EN 61326-2-3: 2006
• EN 61010-1: 2012, Overvoltage Category II
Other standards used:
• EN 50014: 1997 + A1, A2
• EN 50018: 2000
following the provisions of the 2004/108/EC EMC and 94/9/EC ATEX Directives.
Where products were initially assessed for compliance with the Essential Health and Safety Requirements of the
ATEX Directive 94/9/EC using earlier harmonized standards, a subsequent review has determined that "technical
knowledge" is unaffected by the current harmonized standards listed above.
The units listed above and any ancillary equipment supplied with them do not bear CE marking for the Pressure
Equipment Directive. They are supplied in accordance with Article 3, Section 3 (sound engineering practices and
codes of good workmanship) of the Pressure Equipment Directive 97/23/EC for DN<25.
Billerica - September 1, 2015
Issued
GE Sensing
1100 Technology Park Drive
Billerica, MA 01821
USA
T11: KEMA02ATEX2252, T14: KEMA04ATEX2054X,
Series BWT1 / F...PA / XAMP...: KEMA01ATEX2051X; IEC Ex KEM09.0010X
(DEKRA, Ultrechtseweg, 310 Arnhem, The Netherlands - NoBo 0344)
EU DECLARATION
CONFORMITY
T5: KEMA01ATEX2045X,
Mr. Gary Kozinski
Certification & Standards, Lead Engineer
OF
DOC-0028, Rev. H
T8: KEMA02ATEX2283X,
T17: KEMA01ATEX2045X
Advertisement
Table of Contents
