Table of Contents
Advertisement
2.2.1 Identifying the Nozzle Installation Kit Components - Diametrical
The Nozzle Installation Kit includes all of the components required for your diametrical configuration. Before
proceeding, you must identify these parts and verify that they are the correct parts for your installation.
The Nozzle Installation Kit should contain the following items:
•
2 Nozzles (if purchased)
•
2 Welding Bosses
•
1 Jig
•
1 Threaded Rod (1 in. diameter), with Washer and Nut
IMPORTANT: You will need to supply eight 5/8" studs with two nuts each (for 3"x 150# flanges), or eight 3/4" studs
with two nuts each (for 3"x 300# flanges).
Use Figure 4 below to help identify each component.
Model T17 Installation Guide
Nozzle
Jig
Figure 4: Components in Nozzle Installation Kit
Chapter 2. Installing the Pipe Nozzles
Welding Boss
Threaded Rod
with Washer and Nut
5
Advertisement
Table of Contents
