ABB TLE Scalable Series Installation Manual page 21

21/54
Anti-humidity & corrosion devices
B
A
Q1
C
Fig. 4.6-3 TLE Scalable Series 40 to 150
Location of the "Anti-Humidity & Corrosion devices"
PROTECTIVE FOIL
to remove as indicated
in the label
Fig. 3.6-4 TLE Scalable Series 40 to 150
Location of the "Protective Foil"
XA
B
PROTECTIVE FOIL
to remove as indicated
in the label
TLE Scalable Series 40 to 150 UL S1
The package of the TLE Scalable Series 40 to 150
includes the "Anti-Humidity & Corrosion devices"
D
against the formation of humidity and corrosion
during the transportation and the storage of the
A
UPS.
"Anti-Humidity & Corrosion devices" components:
HUMIDITY
INDICATOR
80
A Humidity indicator
%
70
%
B Desiccant bag (2 pcs.)
60
%
C VCI foil base
50
%
D PE stretch foil
40
%
30
%
20
%
B
DESICCANT
Protective foil
TLE Scalable Series 40 to 150 is provided with a "Protective Foil",
on the roof and door/front panels, to prevent material from
falling into UPS.
Warning!
It's mandatory to remove the "Protective Foil" but
only just before the first start-up of the UPS as
indicated in the appropriate label!
The removal of the "Protective Foil" should be
performed only by an ABB Service Technician!
Packing material recycling!
ABB, in compliance with environment protection,
uses only environmentally friendly material.
UPS packing
compliance with all applicable regulations.
UPS Installation Guide / REV-B
Warning!
It's mandatory to remove the "Anti-
Humidity & Corrosion devices" during
the unpacking of the UPS!
Humidity indicator
Before removing the devices "C - VCI foil
base" & "D - PE stretch foil", check the
status of the "A - Humidity indicator".
10% to 70%:
The UPS can be commissioned.
80%:
The UPS shall not be commissioned.
Please contact your ABB Service Center.
materials must be recycled in