Table of Contents
Advertisement
Undo and remove the screw on
the soft-close mechanism and in-
sert a screwdriver behind the soft-
close mechanism.
Remove the soft-close mechan-
ism .
– Fitting the door opening angle lim-
iter
Press a door opening angle limiter
in from above and below as shown.
– Fitting the soft-close mechanism
Insert the soft-close mechanism
on the door hinge side (at an angle
initially) so that it clicks into position.
Then press the other end of the soft-
close mechanism into the opening.
Secure the soft-close mechanism
with the screw .
Push the hinged arm into the
opening on the door hinge.
Insert the pin into the door hinge
from above. Turn this with a screw-
driver (by approx. ¼ turn) until both
lugs on the pin click into position cor-
rectly in the grooves.
Pull out the red safety device .
Tip: Keep the red safety device in case
you want to change the door hinging
again at a later date.
Installation
93
Advertisement
Table of Contents
