ABB S4Cplus Instruction page 33

3RZHU VRXUFHV RI /HYHOPHWHU 
Two alternatives are available:
$GGUHVV
,GHQWLI\ VHQVRUV
5HVXOW
The Levelmeter 2000 is now initialized and ready for service.
3HAC 16578-1 Revision: E
$FWLRQ
4. 0 connect the Levelmeter 2000 to the
COM2 port in the control cabinet through the
connector marked 287 FRQQHFWLRQ 6,2 .
0 connect the Levelmeter 2000 to the
COM1 port in the control cabinet through the
connector marked 287 FRQQHFWLRQ 6,2 .
5. Calibrate the robot!
• Battery mode: turn on the Levelmeter by pressing ON/MODE until display flashes.
This will eliminate battery saving mode. Do not forget to turn off after use.
•
External power: connect the power cords (red/black) to 12-48 VDC, found in the
cabinet or external transformer.
$FWLRQ
1. Make sure the sensors have different addresses. Any
addresses will do, as long as they differ from each
other.
$FWLRQ
1. Connect the sensor to the VHQVRU FRQQHFWLRQ points.
2. Press 2102'(.
3. Press 2102'( until the dot flashes under 6(1625.
4. Press ENTER.
5. Press =(526(/(&7 arrows until a flashing "A B" is
shown.
6. Press (17(5
Wait until the "A B" flashes again.
7. Press (17(5
 3UHSDULQJ WKH HTXLSPHQW
2.2. Start up of Levelmeter 2000
1RWH
/D\RXW DQG
Shown in the figure
FRQQHFWLRQ RI /HYHOPHWHU  RQ SDJH
.
1RWH
Detailed in the documentation
supplied by sensor manufacturer,
found in the calibration tool set.
1RWH
Marked $ and %.
Shown in the figure
FRQQHFWLRQ RI /HYHOPHWHU 
RQ SDJH .
&RQWLQXHG
/D\RXW DQG
31