Bezel Replacement; Replacing A Fan - Hitachi NAS Platform 4000 Series Hardware Reference Manual

Figure 28 Server front metal bezel with grasping areas
Procedure
1. To remove the bezel, grasp the front of the bezel by the grasping areas.
2. Gently pull the bezel straight out away from the server.

Bezel replacement

Procedure
1. Place the bezel on the server, making sure that the bezel fits inside the outer edges
of the chassis and that the retention posts and status LEDs are aligned.
2. Using the solid portions of bezel (near the edges), press the bezel straight into the
server until it is firmly in place against the server chassis.

Replacing a fan

Replace a fan assembly, which is one of the server's hot-swappable components.
Procedure
1. Remove the front bezel. The fan assemblies will then be visible.
2. Identify the fan to be replaced.
Fans are labeled on the chassis, and are numbered 1 and 2, with fan 1 on the left
and fan 2 on the right. Refer to the fan status LEDs on front panel of the server
(behind the bezel) to see which fan has failed. In the following figure, number 1
indicates the status LED for fan 1 (the left-side fan), and number 2 indicates the
status LED for fan 2 (the right-side fan).
Hitachi NAS Platform and Hitachi Unified Storage Series 4000 Hardware Reference
Chapter 5: Replacing server components
Bezel replacement
65