Advertisement
(Optional) Connecting Teamwork Network Cable and Monitoring Cable
6.6
(1) FE_1 (input and output port on the FE ring network)
(2) CAN_IN (input port of the teamwork CAN/northbound
RS485 port)
(3) RS485/12 V (T/H module port)
(4) USB (USB port)
(5) DP (connected to the display port)
(6) COM/FE (northbound RS485 port)
(7) CAN_OUT (output port of the teamwork CAN/northbound
8
Post-Installation Check
RS485 port)
(8) FE_2 (input and output port on the FE ring network)
(9) SW (for restoring factory settings)
(10) Alarm indicator
(11) Run indicator
Teamwork CAN networking (CAN Protocol)
In CAN networking, a maximum of 32 smart cooling products can be teamworked. If CAN
networking is required onsite, set Networking mode on the Teamwork Settings screen of all smart
cooling products to CAN network, and set Teamwork CAN resistor enable on the Teamwork
Settings screen of the first and last smart cooling products to Yes.
Teamwork FE networking (MAC_CAN Protocol)
In CAN networking, a maximum of 16 smart cooling products can be teamworked. If FE networking
is required onsite, set Networking mode on the Teamwork Settings screen of all smart cooling
products to MAC_CAN network.
NetEco Monitoring (Modbus-TCP Protocol/ Modbus-RTU Protocol)
Connect one end of the monitoring network cable (standard network cable) to the COM/FE port on
the main control module, and connect the other end to the monitoring device.
•
Connecting network cables for NetEco FE monitoring (Modbus-TCP protocol)
11
Advertisement
