Storage And Transport - Beko METPOINT BDL portable Instructions For Installation And Operation Manual

7

Storage and transport

Despite all due care and attention, transport damage cannot be excluded. Therefore, check the
®
METPOINT BDL portable for possible transport damage subsequent to transport and removal of the pack-
aging material. The forwarding agent and BEKO TECHNOLOGIES or the BEKO TECHNOLOGIES agency
shall be informed immediately about any kind of damage.
Warning!
Overheating!
Overheating will destroy the evaluation unit. Observe the permissible storage and transport
temperature, as well as the permissible operating temperature (e.g. protect the measuring
device against direct sunlight).
Warning!
Damage possible!
Damage may occur to the METPOINT
Measures
•
The METPOINT ®
personnel.
•
In addition, observe the respectively valid regional provisions and directives.
Caution!
Danger through damaged components!
Do not start-up a damaged METPOINT
operational reliability, falsify the measuring results, and cause further damage.
®
METPOINT BDL portable
®
BDL portable must only be transported or stored by authorised and trained skilled
®
Store the METPOINT
in a closed, dry, and frost-protected room. The ambient tem-
peratures must not exceed/underrun the values indicated on
the type plate.
Protect the device against atmospheric influences even when
packaged.
BDL portable through improper transport or storage.
BDL portable. Defective components can impair the
® BDL portable in its original packaging
Storage and transport
9