Basic Operation (Factory Setting) - Mitsubishi Electric 700 Series Instruction Manual

5.1.2

Basic operation (factory setting)

Operation mode switchover
At power-ON (Network operation mode)*
PU operation mode
(output frequency monitor)
Parameter setting mode
∗ Switching from the Network operation mode to the PU and PU JOG operation modes using
gives a control input signal through FL remote communication. (Refer to page 57.)
Setting "0" in the X12 signal (Bit11) forces PU and PU JOG operation modes to change to Network operation mode.
Value change
Output current monitor
(Refer to page 76)
Value change
Parameter clear
[Operation for displaying faults history]
Past eight faults can be displayed.
(The latest fault is ended by ".".)
When no fault history exists,
Operation panel
PU Jog operation mode
and frequency flicker.
Frequency setting has been
written and completed!!
STOP
Output voltage monitor
Display the
present setting
Parameter and a setting value
flicker alternately.
Parameter write is completed!!
All parameter
clear
Initial value
change list
(Refer to page 188)
is displayed.
is available when "1" is set in the X12 signal (Bit11), which
(Example)
(Example)
Faults history clear
5
75