Lubricating The Brake-Handle Pivot - Toro Z Master 8000 Series Operator's Manual

Figure 30
3. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
4. Loosen the bolt holding the air cleaner
31).
5. Loosen the clamp holding the hose and remove
the air cleaner (Figure
Figure 31
1. Bolt
6. Remove the bolts and the plate below the air
cleaner.
g034248
(Figure
31).
g034250
2. Clamp
1. Plate
7. Lubricate the pump-belt idler arm
8. Install the plate and the air cleaner.
Lubricating the
Brake-Handle Pivot
Service Interval: Every 160 hours
1. Park the machine on a level surface, disengage
the PTO, and engage the parking brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Lubricate the bronze bushings on the
brake-handle pivot with a spray type lubricant
or light oil (Figure
Left Side of Machine Shown
1. Brake-handle pivot
2. PTO-handle pivot
32
Figure 32
2. Bolts
(Figure
33).
Figure 33
3. Spring-arm pivot
4. Toggle pivot
g034251
32).
g006835