Mitsubishi Electric 800 Series Instruction Manual page 56

*4 Output signal can be assigned using Pr.313 to Pr.315.
The settings of Pr.313 to Pr.315 are the same as those of Pr.190 to Pr.196 (output terminal function selection).
For the details of Pr.190 to Pr.196, refer to the FR-E800 Instruction Manual (Function).
*5 "n" indicates a value determined according to the station number setting.
 Remote register
Description
*3
Address
Upper 8 bits
RWwn Monitor code 2
Set frequency (0.01 Hz increments)/
RWwn+1
torque command
*1
RWwn+2
H00 (arbitrary)
RWwn+3 Write data
*1 The above 8 bit is always H00 even if a value other than H00 is set.
*2 When Pr.804 = "3 or 5" during torque control under Real sensorless vector control, a torque command value is set in RWwn+1.
*3 "n" indicates a value determined according to the station number setting.
Refer
to
Lower 8 bits
page
Monitor code 1 66
66
*2
Instruction code 66
66
*3
Description
Address
RWrn First monitor value
RWrn+1 Second monitor value
RWrn+2 Reply code
RWrn+3 Read data
Refer
to
page
69
69
69
69
55
I/O SIGNAL LIST
6