Download Print this page

Toro 34235 Setup Instructions

36in, 46in, and 52in spreader/sprayer
Hide thumbs Also See for 34235:

Advertisement

Quick Links

Loose Parts
Use the chart below to verify that all parts have been shipped. Part numbers not shown are available on the dealer
extranet.
Dealer Pack
Part No.
Literature Pack
Manual, Operator's
Manual, Engine Owner
Checking Tire Pressure
1.
Check the tire pressure in all tires. Proper inflation
is 18 psi (124 kPa).
2.
Adjust if necessary.
Servicing the Battery
Important: The machine is shipped with a filled
lead acid battery.
DANGER
Charging or jump starting the battery may produce
explosive gases. Battery gases can explode causing
serious injury.
• Keep sparks, flames, or cigarettes away from
battery.
• Ventilate when charging or using battery in an
enclosed space.
• Make sure venting path of battery is always open
once battery is filled with acid.
• Always shield eyes and face from battery.
© 2019—
36IN, 46IN, AND 52IN SPREADER/SPRAYER
Description
10W-50 engine oil service classification
SJ or higher
15W-50 hydraulic fluid API rating
CI-4/CF
Qty.
as
Service the engine.
required
as
Service the hydraulic oil.
required
DANGER
Battery electrolyte contains sulfuric acid, which is
poisonous and can cause severe burns. Swallowing
electrolyte can be fatal or if it touches skin can
cause severe burns.
• Wear safety glasses to shield eyes, and rubber
gloves to protect skin and clothing when
handling electrolyte.
• Do Not swallow electrolyte.
• In the event of an accident, flush with water and
call a doctor immediately.
1.
Check the voltage of the battery with a digital
voltmeter. Locate the voltage reading of the battery
in the table below and charge the battery for the
recommended time interval to bring the charge up
to a full charge of 12.6 volts or greater.
Important: Make sure the negative battery
cable is disconnected and the battery charger
used for charging the battery should have
an output of 16 volts and 7 amps or less to
avoid damaging the battery (see chart for
recommended charger settings).
All Rights Reserved *3432-141* A
Part No. 3432-141 Rev. A
Printed in the USA
Setup Instructions
Use

Advertisement

loading

Summary of Contents for Toro 34235

  • Page 1 36IN, 46IN, AND 52IN SPREADER/SPRAYER Setup Instructions Loose Parts Use the chart below to verify that all parts have been shipped. Part numbers not shown are available on the dealer extranet. Dealer Pack Part No. Description Qty. 10W-50 engine oil service classification —...
  • Page 2 Servicing the Hydraulic Oil Percent Voltage Maximum Charging Reading Charge Charger Interval The machine is shipped with hydraulic oil in the Settings reservoir. 12.6 or 100% No Charging 16 volts/7 Run the machine for approximately 15 minutes to greater amps Required allow any extra air to purge out of the hydraulic 12.4 –...
  • Page 3 Installing the Cable/Display Mount Some machines may be shipped with the cable/display mount rotated to the side. Remove and retain the bottom bolt g285170 Figure 2 1. Cable/display mount 3. Top bolt 2. Rotate 4. Bottom bolt Loosen the top bolt enough to rotate the cable/display mount upward.

This manual is also suitable for:

342373423134233