Sony ZRD-1 Service Manual page 79

In the case of the cell assembly at the lowest in the array or at the side end in the array
When you attach the fall prevention tapes, dab the cell assembly for repair against an adjacent cell assem-
bly to the direction of the arrow as shown in the figure. Do not leave a clearance between cell assemblies.
For example, if you are replacing the cell assembly at the a position, dab the cell assembly for repair
against a cell assembly at the upper portion of the side.
Display unit
Display unit
b
a
In the case of the cell assembly at a position
Display unit
In the case of the cell assembly at b position
Do not attach the fall prevention tape to the cell assembly's part which is not in contact to other cell assemblies. Do
not attach the fall prevention tape to the side edge of the cell assembly.
ZRD-1/ZRD-2
Display unit
c
Cell assembly for repair
Cell assembly for
repair
Secure the cell assembly
with the fall prevention
tapes as shown in the figure.
Array
Cell assembly
for repair
In the case of the cell assembly at c position
Display unit
Display unit
Secure the cell assembly
with the fall prevention
tapes as shown in the figure.
Cell assembly for
repair
Secure the cell assembly
with the fall prevention
tapes as shown in the figure.
4-39 (E)