Sony ZRD-1 Service Manual page 31

Category Code on DCS
Temperature 113
113
- -
113 11
Front view
1 2
5 6
9 0
- -
113 31
ZRD-1/ZRD-2
Code on CAS
113- -21
113- -22
- -
14
113- -23
3 4
7 8
!- !=
113- -24
113- -31
- -
113 34
113- -32
113- -33
113- -34
Symptom/Cause/Remedy
Symptom/Cause: Temperature of the cell of 5 shown in the figure on
the left (in the middle line, and first from the left
viewed from the front) is abnormal.
Remedy:
. Check if the air intake hole or the fan is not blocked.
. Lower the temperature around the array.
. Replace the specified cell.
Symptom/Cause: Temperature of the cell of 6 shown in the figure on
the left (in the middle line, and second from the left
viewed from the front) is abnormal.
Remedy:
. Check if the air intake hole or the fan is not blocked.
. Lower the temperature around the array.
. Replace the specified cell.
Symptom/Cause: Temperature of the cell of 7 shown in the figure
on the left (in the middle line, and third from the left
viewed from the front) is abnormal.
Remedy:
. Check if the air intake hole or the fan is not blocked.
. Lower the temperature around the array.
. Replace the specified cell.
Symptom/Cause: Temperature of the cell of 8 shown in the figure on
the left (in the middle line, and fourth from the left
viewed from the front) is abnormal.
Remedy:
. Check if the air intake hole or the fan is not blocked.
. Lower the temperature around the array.
. Replace the specified cell.
Symptom/Cause: Temperature of the cell of 9 shown in the figure on
the left (in the bottom line, and first from the left
viewed from the front) is abnormal.
Remedy:
. Check if the air intake hole or the fan is not blocked.
. Lower the temperature around the array.
. Replace the specified cell.
Symptom/Cause: Temperature of the cell of 0 shown in the figure on
the left (in the bottom line, and second from the left
viewed from the front) is abnormal.
Remedy:
. Check if the air intake hole or the fan is not blocked.
. Lower the temperature around the array.
. Replace the specified cell.
Symptom/Cause: Temperature of the cell of !- shown in the figure on
the left (in the bottom line, and third from the left
viewed from the front) is abnormal.
Remedy:
. Check if the air intake hole or the fan is not blocked.
. Lower the temperature around the array.
. Replace the specified cell.
Symptom/Cause: Temperature of the cell of != shown in the figure on
the left (in the bottom line, and fourth from the left
viewed from the front) is abnormal.
Remedy:
. Check if the air intake hole or the fan is not blocked.
. Lower the temperature around the array.
. Replace the specified cell.
3-13 (E)