Connecting To The App - Aqualisa Visage Smart Series User Manual

Connecting to the App

Before starting you will need your Network Name (SSID code) and
password as they are required during the Aqualisa app setup journey.
These can normally be found on your internet router.
For Wi-Fi set up, the Aqualisa SmartValve
shower must not be in use.
Download and open the Aqualisa app on your
personal smart device and follow the instructions
to create Your Home profile before continuing with
this section.
For further advice, information on compatible
devices, or if you have any trouble downloading the
app scan the QR code or go to www.aqualisa.co.uk/smartapp.
The LEDs on the controller will flash rapidly to indicate
that the Aqualisa SmartValve
available Wi-Fi network. N.B. There is a 2-minute time
out if unable to connect.
Set up Shower - Controller
Wi-Fi setup can be activated
via the main controller for both
Single outlet and Dual outlet
(divert) models.
Press and hold the Start/Stop
button for 6-8 seconds or
until the LEDs on the
controller start flashing.
is searching for an
TM
must be powered, but the
TM
9