H 408x BM
Figure 031-1: Wave Distributor Motor Removal
8. Remove the screws securing the appliance lid. Remove the lid.
Danger!
Before performing any service or repair work, discharge the high-voltage
capacitor. See Section A-2.
9. Disconnect the motor connections (Figure 031-1, Item 4).
10. Remove the two T20 screws securing the motor (Figure 031-1, Item 5).
11. Remove the motor (Figure 031-1, Item 6).
Danger!
After installation is completed, as a matter of standard practice, check the
oven for a tight seal with a microwave leak detector, paying particular attention
to the door and the housing edges.
49
Technical Information