Target Interface Connectors - Xilinx Platform Cable USB II Manual

Target Interface Connectors

Mating connectors for attachment of the high-performance ribbon cable to a target system are available in both through-hole
and surface mount configurations
orientation when inserting the cable. The connector requires only 105 mm
The target system voltage applied to pin 2 of this connector is used as a power source for the output buffers that drive the
output pins (see Target Interface Reference Voltage and Signals, page
Table 5, page 14 provides some third-party sources for mating connectors that are compatible with the Platform Cable USB
II ribbon cable.
X-Ref Target - Figure 14
Slave
SPI Serial
WP INIT
NC NC
MOSI DIN
MISO DONE
SCK CCLK
SS PROG
Vref Vref
Figure 14: Target Interface Connector Dimensions and Signal Assignments
Table 5: Mating Connectors for 2 mm pitch, 14-Conductor Ribbon Cable
(1)
Manufacturer
Molex
FCI
Comm Con Connectors
Notes:
1. Some manufacturer pin assignments do not conform to Xilinx pin assignments. Please refer to the manufacturer's data sheet for more
information.
2. Additional ribbon cables can be purchased separately from the
DS593 (v1.2.1) March 17, 2011
(Figure 14). Shrouded and keyed versions should always be used to guarantee proper
JTAG
HALT 14
NC 12
TDI 10
TDO 8
TCK 6
TMS 4
Vref 2
SMT,
Vertical
87832-1420
98424-G52-14
2475-14G2
2
of board space.
19).
6.30 mm
7.59 mm
2.00 mm
13 PGND
11 GND
9 GND
7 GND
5 GND
3 GND
1
0.50 mm
Through-Hole,
Vertical
87831-1420
98414-G06-14
2422-14G2
Xilinx Online Store.
www.xilinx.com
Platform Cable USB II
12.00 mm
2.00 mm
TYP.
Through-Hole,
Right Angle
87833-1420 www.molex.com
98464-G61-14 www.fciconnect.com
2401R-G2-14 www.commcon.com
16.66 mm
DS593_14_012508
Web Site
14