Function; Clear; Misc-R; Misc-P - Canon imageCLASS MF4890dw Service Manual

FUNCTION

■ CLEAR

COPIER>FUNCTION>CLEAR
Sub item Description
TEL-USER Clear the user data and the registered address data.
SSSW is not cleared.
When this service mode is executed, a message
"REBOOTING..." is displayed on the Control Panel, and
the host machine is automatically restarted.
SRVC-DAT SERVICE DATA is cleared.
User data is not cleared.
HIST Each log data is cleared.
ACT-HIST: Communication log is cleared.
ACT-HIST: Each print log is cleared.
PWD-CLEAR Password of the system administrator is cleared.
ALL The following data are cleared.
• USER DATA
• SERVICE DATA
• JOB ID
• Each log
• CLEAR DATE
USER DATA/ SERVICE DATA are reset to the default
location value.
Appropriate values for LOCAL / SIZE-LC needs to be
preset before executing of CLEAR -> ALL When this
service mode is executed without setting the appropriate
values for LOCAL / SIZE-LC, factory default settings are
continued to use.
When this service mode is executed, a message
"REBOOTING..." is displayed on the Control Panel, and
the host machine is automatically restarted.

■ MISC-R

COPIER>FUNCTION>MISC-R
Sub item
SCANLAMP Execution of lighting function for Scanning Lamp.
8
Service Mode > COPIER > FUNCTION > PARAM
Network
Common
model and
to all
FAX model
models
only
Yes
Yes
Yes
Yes
Yes
T-8-6
Description
T-8-7
8 Service Mode > COPIER > FUNCTION > PARAM

■ MISC-P

● OUTPUT
When outputting the report, place paper in the Pickup Cassette, and remove paper from the
Multi-purpose Tray.
If paper is placed in the Multi-purpose Tray, the report is not output even if paper is placed in
the Pickup Cassette.
COPIER>FUNCTION>MISC-P
Sub item
SRVC-DAT To output the system data list/ system dump list as follows;
SYS-DAT To output the system data list.
Service software switches and parameters used in FAX function are mainly
outputted.
SYS-DMP To output the system dump list.
Service data such as the number of communications, the number of receiving pages
and sending pages, and the number of error are outputted.
CNTR To output the counter report.
Counter values of use trend for reading, storage, communications, and copy are
displayed.
SPEC To output the spec report.
Current device status is printed out.

■ SYSTEM

COPIER>FUNCTION>SYSTEM
Sub item
DOWNLOAD To switch to the download mode.

■ PARAM

COPIER>FUNCTION>PARAM
Sub item
EXC-NAVI To switch of installation navigation.
Setting value
0: Enable (Default)
1: Disable
Set this switch to 1 after the termination of installation navigation.
Installation navigation is not executed when this switch is 1 at next start-up.
When this service mode is executed, a message "REBOOTING..." is
displayed on the Control Panel, and the host machine is automatically
restarted.
8-5
Description
T-8-8
Description
T-8-9
Description
T-8-10
8-5