DeWalt DCM848 Original Instructions Manual
  1. Manuals
  2. Brands
  3. DeWalt Manuals
  4. Sander
  5. DCM848
  6. Original instructions manual

DeWalt DCM848 Original Instructions Manual

Hide thumbs Also See for DCM848:
Table of Contents

Advertisement

Quick Links

DCM848
Final page size: A5 (148mm x 210mm)

Advertisement

Table of Contents
loading

Related Manuals for DeWalt DCM848

Summary of Contents for DeWalt DCM848

  • Page 1 DCM848 Final page size: A5 (148mm x 210mm)
  • Page 2 English (original instructions) Copyright D WALT...
  • Page 3 Fig. A XXXX XX XX Fig. B...
  • Page 4 Fig. C Fig. D...

  • Page 5: Definitions: Safety Guidelines

    English POLISHER DCM848 Congratulations! EC-Declaration of Conformity You have chosen a D WALT tool. Years of experience, thorough Machinery Directive product development and innovation make D WALT one of the most reliable partners for professional power tool users. Technical Data Polisher...

  • Page 6: General Power Tool Safety Warnings

    *Date code 201811475B or later **Date code 201536 or later English Batteries Chargers/Charge Times (Minutes) Weight (kg) DCB104 DCB107 DCB112 DCB113 DCB115 DCB118 DCB132 DCB119 Cat # DCB546 18/54 6.0/2.0 1.05 DCB547 18/54 9.0/3.0 1.46 135* 135* DCB548 18/54 12.0/4.0 1.44 DCB181 0.35...

  • Page 7: Additional Specific Safety Rules

    English h ) Do not let familiarity gained from frequent use of contacts eyes, additionally seek medical help. Liquid tools allow you to become complacent and ignore ejected from the battery may cause irritation or burns. tool safety principles. A careless action can cause severe e ) Do not use a battery pack or tool that is damaged or injury within a fraction of a second.
  • Page 8 English Additional Specific Safety Instructions for chips and cracks, backing pad for cracks, tear or excess wear, wire brush for loose or cracked wires. Polishers If power tool or accessory is dropped, inspect for • Clean out your tool often, especially after heavy use. damage or install an undamaged accessory.
  • Page 9 English Using an Extension Cable charger is ventilated through slots in the top and the bottom of the housing. An extension cord should not be used unless absolutely • Do not operate charger with damaged cord or plug— necessary. Use an approved extension cable suitable for have them replaced immediately.

  • Page 10: Wall Mounting

    English If the charger indicates a problem, take the charger and battery READ ALL INSTRUCTIONS pack to be tested at an authorised service centre. • Do not charge or use battery in explosive atmospheres, such as in the presence of flammable liquids, gases or hot/Cold Pack Delay dust.

  • Page 11: Storage Recommendations

    English batteries of 36 Wh each. The Use Wh rating might indicate materials that could contact them and cause a short circuit. NOTE: Lithium-ion batteries should not be put in 108 Wh (1 battery implied). checked baggage. Storage Recommendations WALT batteries comply with all applicable shipping 1.

  • Page 12: Package Contents

    English Battery Type Auxiliary handle Soft rubber gear case cover The DCM848 operate on a 18 volt battery pack. Wool ingestion shield These battery packs may be used: DCB181, DCB182, DCB183, DCB183B, DCB184, DCB184B, DCB185, DCB187, DCB189, Lock button DCB546, DCB547, DCB548. Refer to Technical Data for Date code more information.

  • Page 13: Prior To Operation

    The trigger switch can only be locked on with the tool Polishing pads with a diameter of 125 mm may be used with running at the maximum RPM designated by the speed control the DCM848. wheel  3  To Attach Polishing Pad With Hook And Loop No-volt release Backing Pad (Fig.

  • Page 14: Maintenance

    2400 RPM slows down to about 2000 RPM under a polishing chemicals may weaken the materials used in these parts. load. Your DCM848 will continue to run at 2400 RPM (or any Use a cloth dampened only with water and mild soap.
  • Page 16 Belgique et WALT - Belgium BVBA Tel: NL 32 15 47 37 63 www.dewalt.be Luxembourg België en Luxemburg Egide Walschaertsstraat 16 Tel: FR 32 15 47 37 64 enduser.BE@SBDinc.com 2800 Mechelen Fax: 32 15 47 37 99 Danmark WALT (Stanley Black&Decker AS)

Table of Contents