Maintenance; Air Filter - Eberg QUBO Q40HD Instruction Manual

IMPORTANT INFORMATIONS
This unit can evaporate the condensation and disperse it automatically through the exhaust
hose.
1. When the unit is in the cooling mode, the drainage pipe does not need to be attached.
Please make sure that the rubber cap is firmly inserted in the drainage hole, when the unit is
running.
2. When operating in the heating mode, the rubber cap "1" should be removed from the
drainage hole and a suitable drainage pipe attached in the order to improve heating
performance.
3. When operating the dehumidifying mode the rubber cap "1" should be removed from the
drainage hole and suitable drainage pipe attached.
• Please remove the air exhaust hose, connect a drainage pipe to the drain hole and direct the
water outside in order to improve dehumidifying performance.
• When the water tank is full, " E4" will be displayed on the display panel. Please remove the
rubber cap"2" from the drainage hole to drain out the water. After the drainage is completed,
please restart the unit and then the unit can operate normally.

MAINTENANCE

Uwaga: PLEASE DISCONNECT THE POWER CORD BEFORE CLEANING

AIR FILTER

When cleaning the filters, take out the baffle plate in the direction indicatsed by the arrow. Take
out filter (1) by sliding upward and filter (2) by sliding downward as shopwn in the image. Be
careful not to get the two filters mixed up
www.eberg.eu
26
QUBO EN