Yamaha DIGITAL MIXING STUDIO 01X Owner's Manual page 96

Function Tree/Function List
Function name/
Knob
settings
4 SOLO MODE
MIX SOLO/
u i
/
LAST SOLO
5 SOLO SAFE
z ,
– ENABLE
MON (Monitor) [UTILITY] → Channel knob 8
1 MONITOR (Monitor Mix Balance)
A (LED-ON)
r
"INT>0: 126<DAW" –
"INT>126: 0<DAW"
B (LED-OFF)
y
"INT>0: 126<DAW" –
"INT>126: 0<DAW"
PAGE [INTERNAL] → ([SELECTED CHANNEL] → [SEL]) → [EQ] / [PAN] / [SEND] / [DYNAMICS] / [GROUP] / [EFFECT]
EQ LOW [INTERNAL] → ([SELECTED CHANNEL]) → [EQ LOW]
EQ LOW GAIN/EQL-G
q i
–
-18.0dB – +18.0dB
y
( )
EQ LOW FREQUENCY/EQL-F
q i
–
21.2Hz – 20.0kHz
t
( )
EQ LOW Q/EQL-Q
q i
– HPF, 10.0 – 0.10,
r
( ) L.SHELF
96
01X Owner's Manual
Explanation
When using the Solo function with the [ON] button ([SOLO] button is on),
this determines whether multiple channels can be soloed (MIX SOLO) or only
the last selected channel is soloed (LAST SOLO).
Input Channels can be configured individually so that they are not muted when
other Input Channels are soloed (Solo Safe function). Signals from Input
Channels that are set to ENABLE are always fed to the Stereo bus, regardless
of the channels' Solo function status.
The audio signals of the last two available channels (the last two numbered
channels specified with mLAN Auto Connector; refer to the separate Installa-
tion Guide) from the DAW which are input to the 01X mLAN channels 17/18
(or 9/10 when set to 96kHz/88.2kHz operation) are output directly to the mon-
itor/headphones output without processing. The settings here let you set the
output balance between the DAW audio and the audio of the 01X itself, and let
you switch between two of these assignments using the [MONITOR] button
—Monitor A (the lamp lights) or Monitor B (the lamp is off). These settings
can also be made by holding the [MONITOR] button and turning the knob [5]
(for A) or [7] (for B).
INT> 0: 126<DAW .....100% DAW audio (no audio from internal mixer)
INT>126: 0<DAW .....100% internal mixer audio (no audio from DAW)
• Pressing the knob sets the balance to 50%-50%
• To restore the default setting (shown above), simultaneously hold down
[SHIFT] and press the corresponding knob.
Adjusts the gain level. When Q is set to HPF, this turns the filter on or off.
Pressing the [EQ LOW] and [EQ HIGH] buttons simultaneously resets all
band parameters (gain, frequency and Q) for the selected channel.
Adjusts the frequency.
Determines the bandwidth of the EQ processing. When Q is set to HPF, the
gain control turns the filter on or off.
Related
Prompt
pages diagram
No
No
[PAGE SHIFT] + DISPLAY [ /
No 37
[PAGE SHIFT] + DISPLAY [ /
No
No
No
Block
]
@7
]