Yamaha DIGITAL MIXING STUDIO 01X Owner's Manual page 86

Function Tree/Function List
Function name/
Knob
settings
m
CLEAR
,
PROTECT
2 PATCH LIBRARY ASSIGN
IN-PATCH
(Input Patch)
00 – 32
n ,
/
OUT-PATCH
(Output Patch)
00 – 32
3 RECALL SAFE
ENABLE
z ,
–
---- (disable)
UTILITY MODE [UTILITY]
BACKUP [SHIFT] + [UTILITY]
m
NO
,
YES
86
01X Owner's Manual
Explanation
This deletes the selected Scene.
• You can turn write-protect on for specific important Scenes that you wish to
keep from inadvertently overwriting or deleting. (See "Protect" below.)
This turns write-protect on for Scenes that you wish to keep from inadvert-
ently overwriting or deleting. The protected Scenes are indicated by asterisks
(*) in the display and cannot be selected for the Store destination or Clear
source.
This determines the Library numbers of the specific Input Patch and Output
Patch settings you wish to recall with the Scene. Select the desired number by
turning the appropriate channel knob, [6] or [8]. (The display indication
flashes.) To revert to the original value without changing it, hold down
[SHIFT] and press the knob. To actually assign the desired number, press the
knob. The Patch assignments are stored with the Scene.
This function allows you to exempt certain channels from being changed when
recalling a Scene. Set the channel(s) you wish to keep unchanged to
"ENABLE." To set the stereo master channel, press the [SEL] button of the
STEREO channel and press knob [8]. (To return to normal selection, press any
one of the channel [SEL] buttons.) The Recall Safe settings are stored with
the Scene.
The parameters affected by Recall Safe are: channel fader (level), channel on/
off, pan, EQ, Dynamics, Aux Send on/off, Aux Send Pre/Post, and Aux Send
level.
This operation saves the current settings of the 01X to internal memory so that
when the device is turned on again, all previous settings are restored automati-
cally.
The following settings are NOT memorized by Backup:
• The parameter display status (NAME/VALUE setting or meter indication)
• The channel display status (Selected Channel or Multi Channel)
• The Flip status
• Remote mode status and all Remote mode settings
• Parameters that cannot be stored in Libraries and parameters that you
have not yet saved can be memorized by the Backup function. If not
memorized, they will be lost when turning off the power. Make sure to
save or back up important data.
• Any and all previous backup data will be lost when executing Backup.
Make sure to save and archive important data to computer using the Stu-
dio Manager program (page 9).
Related Block
Prompt
pages diagram
Yes
65
Yes
88
No
90
No
Yes
Yes