Simple Remote Controller (Uty-Rsry, Uty-Rhry); Simple Remote Controller (Uty-Rsku, Uty-Rhku) - Fujitsu Airstage J-II Series Design & Technical Manual

„ SETTING UP EACH INDOOR UNIT
„
Indoor unit
01
Simple remote
controller
Repeat the procedures in steps 1) through 13), and set up the indoor units
requiring address setting.
„ RESET THE POWER AFTER SETTING UP ADDRESS OF ALL
„
INDOOR UNITS
Important
¾ If the reset is not performed, address cannot be read in normally.
„
¾ After all the addresses have been set, the circuit breaker needs to be switched off
„
for at least 2 minutes.
After the 2 minutes has passed, power can be restored.
¾ The set address is stored in the PCB and will remain in memory even when the
„
power is turned off.
However setting address is effective after power reset.
Record the address set in the indoor unit on a label, etc., and affix the label to the
unit so it can be used for after-sales service operations.
Indoor unit Indoor unit
00 0 01 01 1 01 02 2
- (07 - 38) -
Indoor unit Indoor unit
01 13 0 01
Simple remote Simple remote
controller controller
Indoor unit
14 1 01 15 0