Advertisement
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
The hose-reel mount is designed to fit aftermarket hose reels with mounting patterns of either 40 x 23 cm (15-3/4 x 9
inches) or 39 x 25 cm (15-7/16 x 10 inches).
Toro recommends the following aftermarket hose reels:
•
Reelcraft—CA33112L
•
Cox—1125-5-100
Important: The total load capacity when this kit is installed is 45 kg (100 lb). When installing the hose reel, verify
that the hose length, when full of water, does not exceed 45 kg (100 lb), or damage may occur.
Important: After installing the hose-reel mount to the machine, the length of the front or rear of the machine
extends, making it more likely to hit other objects.
Ensure that there is always adequate clearance when operating the machine with the hose-reel mount installed.
WARNING
Lifting the hose-reel mount with the hose reel installed alone may result in injury.
When lifting the hose-reel mount with the hose reel installed, ensure that you have 2 people to install it
to the machine.
1
Preparing the Machine
No Parts Required
Procedure
Park the machine on a level surface, set the parking brake, shut off the engine, and remove the key.
Description
No parts required
Hose-reel mount
Tube mount
Hex-head screw (1/2 x 2-1/4 inches)
Locknut (1/2 inch)
Clevis pin (1/2 x 2 inches)
Hairpin cotter
Qty.
–
Prepare the machine.
1
1
1
Install the hose-reel mount.
1
1
1
2
Use
Advertisement
