Samsung AE RXYDEG Series Installation Manual page 22

Installing the unit
Outdoor unit installation
The outdoor unit must be installed on a rigid and stable base to avoid any increase in the noise level and vibration,
particularly if the outdoor unit is to be installed in a location exposed to strong winds or at a height, the unit must be fixed to
an appropriate support(wall or ground).
Fix the outdoor unit with anchor bolts.
The anchor bolt must be 20mm or higher from the base
surface.
NOTE
When tightening the anchor bolt, tighten the rubber washer
to prevent the outdoor unit bolt connection part from
CAUTION
corroding.
Make a drain outlet around the base for outdoor unit
drainage.
If the outdoor unit is installed on the roof, you have to check
the ceiling strength and waterproof the unit.
Outdoor unit support
OUTDOOR UNIT INSTALLED ON THE WALL BY RACK
Ensure the wall will be able to suspend the weight of rack and outdoor unit ;
Install the rack close to the column as much as possible ;
Install proper grommet in order to reduce noise and residual vibration
transferred by outdoor unit towards wall.
When installing air guide duct
Check and make sure that screws do not damage the copper pipe.
CAUTION
Secure air guide duct on guard fan.
22
Anchor bolt hole
620
940
Outdoor
unit
Anchor bolt
Soft rubber designed to cut off
vibration from rack to wall. (not
supplied with product)
(Unit : mm)
Outdoor unit
support
Base surface
Designed to
cut off residual
vibration from
outdoor unit to
rack. (not supplied
with product)