Samsung AE RXYDEG Series Installation Manual page 15

Deciding on where to install the outdoor unit
Decide the installation location regarding the following condition and obtain the user's approval.
The outdoor unit must not be placed on its side or upside down, as the compressor lubrication oil will run into the cooling
circuit and seriously damage the unit.
Choose a location that is dry and sunny, but not exposed to direct sunlight or strong winds.
Do not block any passageways or thoroughfares.
Choose a location where the noise of the Air to Water Heat Pump when running and the discharged air do not disturb
any neighbours.
Choose a position that enables the pipes and cables to be easily connected to the other hydrauric system.
Install the outdoor unit on a flat, stable surface that can support its weight and does not generate any unnecessary noise
and vibration.
Position the outdoor unit so that the air flow directly stream towards the open area.
Place the outdoor unit where there are no plants and animals because they may cause malfunction of outdoor unit.
Maintain sufficient clearance around the outdoor unit, especially from a radio, computer, stereo system, etc.
Installation Guide at the seashore
Make sure to follow below guides when installing at the seashore.
1. Do not install the product in a place where it is directly exposed to sea water and sea breeze.
- Make sure to install the product behind a structure (such as building) that can block see breeze.
- Even when it is inevitable to install the product in seashore, make sure that product is not directly exposed to sea
breeze by installing a protection wall.
2. Consider that the salinity particles clinging to the external panels should be sufficiently washed out.
3. Because the residual water at the bottom of the outdoor unit significantly promotes corrosion,
make sure that the slope does not disturb drainage.
- Keep the floor level so that rain does not accumulate.
- Be careful not to block the drain hole due to foreign substance
4. When product is installed in seashore, periodically clean it with water to remove attached salinity.
5. Make sure to install the product in a place that provides smooth water drainage. Especially, ensure that the base part has
good drainage.
6. If the product is damaged during the installation or maintenance, make sure to repair it.
7. Check the condition of the product periodically.
- Check the installation site every 3 months and perform anti-corrosion treatment such as R-Pro supplied by SAMSUNG
(Code : MOK-220SA) or commercial water repellent grease and wax, etc., based on the product condition.
- When the product is to be shut down for a long period of time, such as off-peak hours, take appropriate measures like
covering the product.
8. If the product installed within 500m of seashore, special anti-corrosion treatment is required.
❋ Please contact your local SAMSUNG representative for further details.
Outdoor
Sea breeze
Sea
unit
15