Setting⑩ : Illumination(Led) Setting - Mitsubishi Electric KD Series User Manual

5-2 Setting⑩: Illumination (LED) Setting
Address Register name
7014h LedPulseDivision
7018h LedPulseWidthA
701Ch LedPulseWidthB
7020h LedEffectivePeriod
5-2-12 Illumination (LED) Control
[Function]
Set the output of the lighting pulse signal for external lighting
control. By changing the pulse width of illumination, you can
adjust the intensity of the illumination.
The controll of both Upper-stream side illumination(A) and
Lower-stream side illumination(B) can be controlled
independently.
You can also division the number of Lighting pulse signal 1 to 8
pulses within 1 line cycle of illumination.
[Remark]
1) Maximum illumination Pulse Width is equivalent to the
setting value of illumination Effective Period. If you set
illumination Pulse Width longer than illumination Effective
Period, the illumination is NOT turned ON after the end of
illumination Effective Period.
2) Please Include an appropriate margin of line frequency
variation when you set illumination Effective Period.
3) If you set illumination Effective Period longer than Line Cycle,
reset at Initialize the next sync signal or the next timing of
illumination Effective Period.
TM-XJ959A
R/W Parameter
Data
Set illumination Pulse division
R/W 0 to 3
0:OFF, 1: 2 pulses, 2: 4 pulses, 3: 8 pulses
Upper-stream side (A) illumination (OUT PULSE1) period
R/W 0 to 65535 setting
Lower-stream side illumination (B) (OUT PULSE2) period
R/W 0 to 65535
setting
Set illumination Effective Period
R/W 0 to 65535
Function
‫= ܿ݁ ݏݑ݀݋ ݅ݎ݁݌ ݃݊ ݅ ݐ݄݃ ݅ܮ‬
Illumination Effective Period ‫= ܿ݁ݏݑ‬
External Sync signal
Sync latency
Internal Sync signal
OFF period
Illumination (LED)
pulse signal
Initial
0
ܴ݁݃݅ ‫݁ݑ ݈ܽݒ ݎ݁ ݐݏ‬
35
450
450
ܴ݁݃݅ ‫݁ݑ ݈ܽݒ ݎ݁ ݐݏ‬
35
692
Line cycle
*N=number of pulse
77
© Mitsubishi Electric Corporation