Setting⑨: Illumination(Led) Control - Mitsubishi Electric KD Series User Manual

5-2 Setting⑨: Illumination(LED) Control
Address Register name R/W
7010h LedSelector R/W
5-2-11 Illumination (LED) Control
[Function]
This product perform the control of a lighting pulse signal
for outside illumination.
The format of output signals suppose the construction of
illumination which is shown below.
Upper-stream side illumination(A)
Lower-stream side illumination(B)
Glass
TM-XJ959A
Parameter
Data
Illumination ( LED) control
0: OFF (Signal is not outputted from OUT PULSE1 and OUT PULSE2)
1: Upper-stream side illumination(A), one side lighting ON
(Signal is outputted from OUT PULSE1)
0 to 3
2: Lower-stream side illumination(B), one side lighting ON
(Signal is outputted from OUT PULSE2)
3: Both Upper-stream illumination(A) and Lower-stream illumination(B) ON
(Signal is outputted from OUT PULSE1 and OUT PULSE2)
Function
[Remark]
1) Sequential multiple different illuminations are not
supported by this product. In this case, White
Correction cannot be operated, too. When you select
one of the illumination control modes, you can save
White Correction data and run White Correction.
2) As illumination Control function, This product outputs
External illumination pulse signal over External
Connector L1. For more details, refer to Page 52 and
58.
Initial
3
76
© Mitsubishi Electric Corporation