Toshiba Strara CTX Series Installation And Maintenance Manual page 61

8. To mount the Expansion Cabinet, position it onto the back cover hangers.
Position the cabinet over the bottom right hanger first, and then carefully tilt the cover over the
Note
top two hangers.
9. Slide the Expansion Cabinet to the left, feeding the data ribbon cable through the side hole of the
Expansion Cabinet.
10. Finish by securing the Expansion Cabinet to the Base cabinet with the two screws in front of the
cabinets where they join together. The expansion cabinet left-side flange fits over the Base cabinet
right side flange (see
11. On the AMAU motherboard of the Expansion Cabinet, flip open the two data ribbon locks, plug in
the data ribbon and close the locks. The data ribbon cable should now be connected to the Base
and Expansion cabinets.
12. Install PCBs into the Expansion Cabinet; follow the instructions in
into the Cabinet(s)".
Note The Base Cabinet DC power switch will be the master control for turning the DC power of
both cabinets On/Off.
13. Attach the outside covers on the Expansion Cabinet.
L eft side of Expansion C abinet fits over
the right side of the Base C abinet.
2 - S c rews
Figure 2-7 Base and Expansion Cabinet Interior
Strata CTX I&M September 2002
Figure 2-7).
S 101 S 102 S 103 S 104 S 105 S 106 S 107 S 108
Strata CTX100 Installation
"Step 10: Install Other PCBs
F lip open loc ks to plug in data c able. P ush
loc ks c losed onc e c able is plugged in. Make
sure loc ks are c losed.
5969
2-9