Toshiba Strara CTX Series Installation And Maintenance Manual page 105

Bolt Cabinets to Wooden Floor
1. Mount the CTX670 Base Cabinet on Floor
Mount Fixtures (BFIF). See
3-16.
2. Position the Base Cabinet at the selected
installation location.
3. Mark the floor where holes will be drilled.
Move the Base Cabinet prior to drilling.
Cover the Base Cabinet with a drop cloth to
Note
protect the power equipment from dust
created during drilling.
4. Drill pilot holes to make insertion of 3/8 inch
lag bolts easier, and to prevent splitting of
wood flooring.
5. Move the Base Cabinet into position on the equipment room floor.
6. Secure the Base Cabinet to the floor using lag bolts, lock washers, and flat washers.
Bolt Cabinets to Computer Room Floor
1. Mount the CTX670 Base Cabinet on Floor Mount Fixtures (BIMF). See
2. Position the Base Cabinet at the selected installation location.
3. Mark the floor where holes will be drilled. Move the Base Cabinet prior to drilling.
Cover the Base Cabinet with a drop cloth to protect the power equipment from dust created
Note
during drilling.
4. Drill holes through tile for 3/8-inch threaded rods.
5. After the tiles have been drilled, insert threaded rods through the holes in the tile and mark the
concrete floor directly beneath the holes in the tiles.
6. Remove the tiles. Use a hammer drill to make holes for 3/8-inch bolt anchors.
7. Install the bolt anchors with plugs in the
drilled holes.
8. Using the driving tool and a hammer, drive
each bolt anchor into the floor.
9. Screw threaded rods into each bolt anchor.
10. Install a hex nut, lock washer, and flat washer
on each threaded rod. Screw the nuts down far
enough to allow floor tiles to be replaced over
the threaded rods.
11. Replace tiles over threaded rods in their
original positions on the floor.
12. Reach under the tiles, and screw the hex nuts
upward until the flat washers are touching the
bottom of the tile.
Strata CTX I&M September 2002
Figures 3-15 and
Figure 3-19
Strata CTX670 Installation
Base
Cabinet
BFIF
(Floor
mount
fixture)
Wooden
Floor
Figure 3-18 Installation on Wooden Floor
Figures 3-15
Bottom
Cabinet
BFIF
(Floor
mount
fixture)
Floor Tiles
Flat Washer
Lock Washer
Lead Anchors
Hex Nut
Concrete
Installation on Computer Room
Bolt
Lockwasher
1468
and 3-16.
1469
3-31