Ctx670 Processor Pcb Subassemblies; Ctx670 License Control - Toshiba Strara CTX Series Installation And Maintenance Manual

CTX670 Processor PCB Subassemblies

Subassemblies can be added to the processor PCBs to enable system expansion and provide additional
features. The subassemblies are:
BEXS and BBMS expansion PCBs mount onto the processor PCBs to provide increased port
capacity, from Basic (192 ports) to Expanded (672 ports). The BEXS provides switching capacity,
and an additional 16 DTMF receivers and 16 Busy Tone detectors. The BBMS provides memory
capacity. For Basic and Expanded capacities of stations, lines and features, see
expand the system, both subassemblies must be installed.
BSIS interface PCB which attaches to the BECU to provide up to four RS-232 interface ports for
SMDR Call Accounting and SMDI or Toshiba Proprietary Voice Mail interface.
See Table 1-3 on Page 1-10
Expanded systems.

CTX670 License Control

The system size and feature capability is controlled using a software License Key Code. This key code
is obtained from (http://www.toshiba-telecoms.co.uk/dealer) during the ordering process and is
installed onto the system processor via Strata CTX WinAdmin. Processor license codes activate
system hardware capacities in the following increments.
The first 64 line/station ports do not require a license. Each additional set of four line/station ports
requires one CTX670 PORT LIC license (maximum of 672 ports).
The on-board DTMF receiver circuit provides up to 32 DTMF receiver hardware circuits. The first
four DTMF circuits do not require a license. Each additional set of four DTMF receiver circuits
requires one CTX670 DTMF LIC license (max. total of 32 DTMF circuits).
DTMF tone receiver circuits are required for standard telephones, Voice Mail DTMF
Note
integration, Tie, DDI and DNIS line service.
The optional RS-232 serial port interface (BSIS) provides two circuits to interface with Voice Mail
SMDI or Toshiba Proprietary Voice Mail integration, Call Accounting SMDR, and two for future
applications. The first circuit does not require a license, but circuits two through four each require
one CTX670 SERL LIC license.
The list below outlines all the licenses that can be purchased for CTX670 and their associated
capacities.
CTX670 PORT LIC- Purchase of ONE license will increase system ports by 4. Max 672
CTX670 DTMF LIC- Purchase of ONE license will increase DTMF receivers by 4. Max 16
CTX670 CSTA LIC- Purchase of ONE license will increase CSTA sessions by 1. Max 9
CTX670 QSIG LIC- Purchase of ONE license will enable QSig on the switch.
CTX670 WOC LIC- Purchase of ONE license will allow 1 WOC to be supported. Max 4.
CTX670 SERL LIC- Purchase of ONE license will allow 1 serial port to be supported. Max 4
but only two have a use at present.
Strata CTX I&M September 2002
for the number of cabinets and universal PCB slots for the Basic and
Strata CTX Configuration
Tables 1-3~1-8. To
1-7