Toshiba Strara CTX Series Installation And Maintenance Manual page 104

Strata CTX670 Installation
RWBFs are used on left and
right sides, wherever indicated
"A"
Front two
screws, left
and right sides
"B"
A B
Back two
screws, left
and right sides
A B
BFIF
Note
RWBF (3-pairs) and BFIF Stands (1-pair) are supplied with floor installation kit BFIF.
Figure 3-16 Floor Mounting Cabinet Installation
Bolt Cabinets to Concrete Floor
1. Mount the CTX670 Base Cabinet on Floor
Mount Fixtures (see
Position the Base Cabinet at the selected
installation location.
2. Mark the floor where holes will be drilled.
Move the Base Cabinet prior to drilling.
Note Cover the Base Cabinet with a drop cloth
to protect the power equipment from dust
created during drilling.
3. Use a hammer drill to make holes for 3/8-
inch bolt anchors.
4. Install the bolt anchors, with plugs, in the
drilled holes.
5. Using the driving tool and a hammer, drive
each bolt anchor into the floor.
6. Move the Base Cabinet into position on the equipment room floor.
7. Secure the Base Cabinet to the floor using bolts, lock washers, and flat washers.
3-30
A
RWBF
A B
A
RWBF
RWBF
A B A
B
A A
RWBF
RWBF
BFIF BFIF
BFIFs are used on left and
right sides, wherever indicated
Figures 3-15 and 3-17).
A B
RWBF
B A B
B A B
RWBF
B A B
B A B
RWBF
BFIF
Bottom
Cabinet
BFIF
(Floor
mount
fixture)
Figure 3-17 Installation on Concrete Floor
RWBF
A B
RWBF
RWBF
A B
A B
A B
RWBF RWBF
A B
A B
RWBF
BFIF
5007
Bolt
Lockwasher
Bolt Anchor
Concrete
Floor
Plug
Strata CTX I&M September 2002
5242