Canon Oce BLM550+ Operation Manual page 99

• Flat blade screwdriver.
Step Action
1 Lift the Booklet maker main deck.
2 Remove the wire-holder from the
stitch head.
3 Inspect the area behind the wire-
holder for stitch-wire.
4 Remove any stitches or pieces of
stitch-wire and clean the area with
the air duster.
5 Lubricate the stitch-head.
6 Fit the wire-holder.
7 Close the Booklet maker.
8 Start the Booklet maker.
Information
See Lift the Booklet maker Main Deck on
page 49
• Move the wire-holder retaining spring to
the right.
• Remove the wire-holder
If the wire-holder is held in position, use a
screwdriver to help remove the wire-holder
from the stitch head.
IMPORTANT
Attention: Do not apply force to
the wire guide bars or the pivot
block.
Use wire cutters to remove any jammed
stitches or pieces of stitch-wire.
Lubricate the Stitch Head on page 118
Remember to put the wire-holder retaining
spring in position.
If the head operates normally and returns to
the parked position, then further action is
not needed.
If the stitch-head remains jammed, then re-
peat the procedure again.
If the problem continues, contact your serv-
ice engineer.
Chapter 6 - Error Conditions, Problems and Solutions
Procedure 2
99