Canon Oce BLM550+ Operation Manual page 78

Error Messages
Problem
ENDLAY - No comms
ERROR IN TRIM AREA
ERROR - No comms
FLOW ERROR - BRIDGE
FLOW ERROR - FORMER
FLOW ERROR - GATHER AREA There is a paper jam in the
FLOW ERROR - OUTFEED
FLOW ERROR - STITCHER
78 Chapter 6 - Error Conditions, Problems and Solutions
Cause
Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
There is an error at the trim-
mer.
Check the trimmer for a paper
or book jam.
Touch STOP to clear the
message from the screen.
Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
There is an error at the con-
necting bridge. Open the con-
necting bridge cover and
check for a paper jam.
Touch STOP to clear the
message from the screen.
There is an error at the former.
Open the folder cover and re-
move the book. If necessary,
open the main deck to remove
the book.
gathering area. Open the con-
necting bridge cover, lift the
gathering area and remove
the paper jam.
There is an error at the out-
feed. Remove the trim bin and
open the trim stop guard to re-
move the book.
If necessary, open the main
deck to remove the book.
There is an error at the stitch-
er. Open the folder cover and
remove the book.
If the problem continues, then
call your service engineer.
Solution
Clear Paper Jams on
See
page 85
Jam in the Folder or For-
See
mer Area on page 90
See Jam in the Gathering Area
on page 88
Jam in the Trim Area on
See
page 93
Jam in the Stitch Area on
See
page 89
4