Table of Contents
Advertisement
Problem
BRIDGE MOTOR STALL
BRIDGE - No comms
CHECK PAPER SIZE
CHECK THE TRIM BIN
COVER OPEN
DFA INTERFACE - No comms
DRIVE MOTOR STALL
Endlay axis moving
Cause
Check for a paper jam in the
connecting bridge.
• Touch STOP
to stop the
Booklet maker.
• Clear the paper jam.
• Touch STOP
to clear the
message from the screen.
• Continue the print job.
Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON.
If the problem continues, then
call your service engineer.
Remember to check the paper
size.
To make an accurate book you
must enter accurate paper di-
mensions into the touch
screen.
Measure the size of the prin-
ted paper. The paper dimen-
sion changes when the paper
is printed.
The trim bin is either open or
full. Check the trim bin. Empty
the trim bin if necessary.
A safety cover is open. The
machine will not operate until
the cover is closed.
Use the mains ON/OFF switch.
Turn the machine OFF, then
turn the machine ON. If the
problem continues, then call
your service engineer.
There is a paper jam. Check
the machine and correct the
error.
Touch STOP
to clear the
message from the screen.
The endlay axis (size adjust-
ment) is moving. This mes-
sage clears when the adjust-
ment is complete.
If the message does not clear,
touch ADVANCED > RE REF.
Chapter 6 - Error Conditions, Problems and Solutions
Error Messages
Solution
Clear Paper Jams on
See
page 85
4
77
Advertisement
Table of Contents
