Canon Oce BLM550+ Operation Manual page 22

Procedure for a New Job
Step Action
5 Enter the sheet thick-
ness.
Or
Enter the set thick-
ness. See
structions on page
6 Enter the number of
stitches.
7 Enter the spine form
setting
8 Enter the trim setting.
9 Touch CLOSE
If needed, save the job
settings to memory.
22 Chapter 3 - How to run the Booklet maker
Information
Touch SET THICKNESS. Set AUTO to ON. Use '+' or '-' to en-
ter the SHEET THICKNESS.
Touch SET THICKNESS. Set AUTO to OFF. Use '+' or '-' to en-
Quality in-
ter the SET THICKNESS.
18.
Touch STITCHES and enter the number of stitches. If needed,
the stitch pitch can be changed. See "STITCH PITCH,"
overview on page 33
The spine form setting is automatic, according to the SET
THICKNESS setting. If needed, the setting can be changed.
See "FORM" in
The trim setting is automatic, according to the PAGE SIZE
and SET THICKNESS settings. To change the setting, touch
TRIM. See "TRIM" in
If the same job settings are used frequently, then save the job
settings to memory.
Load and Save the Job Settings on page
See
Button overview on page 33
Button overview on page 35
Button
42.