Table of Contents
Advertisement
2
1
Figure 15
1. Jumper wire harness
2. R.H. lamp mount
3. Harness clip
3. Mount the rear lamp to lamp mount with bolts and
nuts included with the lamp (Figure 15).
Note: Make sure the lamp is positioned so the plug is
through the hole in the lamp mount and the amber end
is toward the outside of the machine.
4. Repeat the procedure on the right side of the machine.
5. Plug the enclosed rear light wire harness jumpers into
the harness connectors of the machines rear wire
harness.
6. Route the right harness under the right side of the
traction unit to the right rear lamp. Plug the harness
connector into the lamps pig tail connector (Figure 15).
7. Route the left harness under the left side of the traction
unit to the left rear lamp. Plug the harness connector
into the lamps pig tail connector (Figure 15).
8. Secure the wiring harness and jumper wires the harness
clips and cable ties.
5
4
1
3
g021710
4. L.H. lamp mount
5. Rear lamp (2)
8
Installing the Fuses
Parts needed for this procedure:
3
Fuse, 10 amp
Procedure
Insert the 10 amp fuses into the fuse block slots shown in
Figure 16 and Figure 17.
1
1. Fuses, 10 amp (3)
1
1. Fuse locations on decal
9
Figure 16
Figure 17
g021712
g02171 1
Advertisement
Table of Contents
