Table of Contents
Advertisement
Figure 7
1. Bolt, washer and nut (2)
2. Install a rubber grommet into the hole in each headlight
bracket (Figure 8).
3. Fasten the R.H and L.H. headlight brackets to the
front of the operator's platform with the bolts, washers
and nuts previously removed. Position the brackets as
shown in Figure 8.
2
3
4
5
Figure 8
1. Wire harness
2. Headlight assembly, R.H.
3. Headlight bracket, R.H.
4. Headlight bracket, L.H.
4. Fasten the R.H and L.H. headlight assemblies to
the headlight brackets (Figure 8) with the fasteners
supplied with the lights. Make sure the turn signal lens
on the headlight is positioned toward the outside of
the machine.
5. Plug the connector body from the enclosed headlight
wire harness into the harness connector of the steering
tower wire harness under the steering cover opening.
g021734
1
7
6
5. Harness clip
6. Rubber grommet
7. Headlight assembly, L.H.
6. Route the headlight wire harness underneath the front
edge of the operator's platform.
7. Insert each harness connector through the end of the
appropriate harness bracket, out the hole (grommet)
and connect it to the headlight (Figure 8).
8. Secure the headlight wiring harness to the headlight
brackets and operator's platform with the harness clips
and cable ties.
9. Install the steering tower cover.
For Groundsmaster 4010 and 4110,
Models 30602, 30603 30606 and 30607
1. Fasten the headlight brackets to the existing brackets
on the front of the cab with screws (1/2 x 1 inch) and
locknuts (1/2 inch). Position the brackets as shown
in Figure 9.
2
3
4
5
3
1. Wire harness
g021709
2. Headlight assembly, R.H.
3. Headlight bracket (2)
2. Fasten the R.H. and L.H. headlight assemblies to
the headlight brackets (Figure 9) with the fasteners
supplied with the lights. Make sure the turn signal lens
on the headlight is positioned toward the outside of
the machine.
3. Plug the connector bodies from the enclosed headlight
wire harness into the harness connectors of the steering
tower wire harness.
4. Route the headlight wire harness underneath the front
edge of the operator's platform and connect it to the
headlights (Figure 9).
6
1
6
Figure 9
4. Headlight assembly, L.H.
5. Screw, 1/2 x 1 inch
6. Locknut, 1/2 inch
g021707
Advertisement
Table of Contents
