Table of Contents
Advertisement
Figure 12
1. Plate
2. Right cover
2. Remove the (6) screws that secure the right cover to
the right side of the control arm (Figure 12).
Note:
3. From inside the control arm switch panel, press the
plug out of the hole in the side of the control panel
(Figure 13).
1
Figure 13
1. Plug
4. Press the switch into the control panel mounting hole
(Figure 13).
5. Locate the wire harness under the control panel. Plug
the wire harness connector labeled "lights" into the
switch.
6. Install the cover and plate to the right side of the
control arm.
3. Control arm
g021722
2. Switch
7
Installing the Rear Lamps
Parts needed for this procedure:
1
L.H. light mount
1
R.H. light mount
2
Rear lamp assembly
2
Jumper wire harness
2
Harness clip
Procedure
1. Remove the top bolt, washer and nut securing the
rear bumper bracket to the left frame rail (Figure 14).
Retain the bolt, washer and nut.
g021723
1. Rear bumper bracket bolt, washer and nut
2. Using the bolt, washer and nut previously removed,
secure the L.H. lamp mount to the bracket and frame
(Figure 15). Make sure the bottom hole in the lamp
mount is positioned over the bottom bumper mounting
bolt.
Note: The L.H. and R.H. lamp mounts are different.
Make sure to use the correct mount.
8
Figure 14
Advertisement
Table of Contents
