ROLEC EV Series Installation Instructions

This instruction is applicable to the following EV AutoCharge Pedestal products:
EVTM0012, EVTM0013, EVTM0022 & EVTM0023.
INSTALLATION INSTRUCTIONS
All installation work is to be carried out by a competent and suitably qualified engineer.
1. Carefully remove the pedestal and mounting base (if supplied) from the packaging and check that both
are undamaged.
2. If a base is supplied:

Prepare and set the ground mounting base in the desired location. Concrete into place, with the
electrical service cable fed up through the middle of the base

Unlock and remove the access door at the front of the unit, taking care not to disturb the earth
bonding lead attached to it

Remove the four screws securing the internal face plate; remove the plate to gain access to the
interior

Carefully lift the pedestal and fit the chassis onto the ground mounting base, aligning the four
holes in the chassis with the four studs of the base

Feed the electrical cable up through the chassis base plate

Secure the chassis to the ground mounting base with the supplied nuts and washers
3. If a base is not supplied:

Prepare a suitable area of flat ground with a means of fixing the chassis of the pedestal to the
ground

Unlock and remove the access door at the front of the unit, taking care not to disturb the earth
bonding lead attached to it

Remove the four screws securing the internal face plate; remove the plate to gain access to the
interior

Carefully lift the pedestal and secure in place with suitable fastenings

Feed the electrical cable up through the chassis base plate
4. Terminate the supply cable in the appropriate manner and connect to the pedestal 3 Phase, Neutral
and Earth terminals.
5. Switch on the overload/fault current device.
6. Refit the internal face plate and secure with the four screws.
7. Fit and lock the access door; remove the key.
8. Switch on the power to the unit and test in accordance with current regional electrical regulations.

OPERATING INSTRUCTIONS

Status Indicator Guide


Flashing blue light - Ready for Charge (IEC socket only)

Fixed blue light - Cable plugged in but not charging

Fixed green light - Charging in progress

Flashing red light - Fault indicated - Switch off unit at source and switch back on after 20 secs to
clear fault. If fault persists, contact your installer

Vehicle Charging


Obtain a token from the operator

Chose an available charging socket

Ensure the status indicator shows a blue light
EV: AUTOCHARGE PEDESTAL
COIN/TOKEN PAYG SUPERFAST
Doc No.: EVAUTI-004 Rev: 01