ROLEC EV Series Installation Instructions

This instruction is applicable to the following BasicCharge EV Pedestal products: EVCL2005, EVCL2006,
EVCL2015, EVCL2016 & EVCL2024
INSTALLATION INSTRUCTIONS
All installation work is to be carried out by a competent and suitably qualified engineer.
1. Carefully remove the pedestal and mounting base (if supplied) from the packaging and check that both
are undamaged.
2. If a base is supplied:

Prepare and set the ground mounting base in the desired location, making sure the base top
surface is two or three millimetres higher than the ground level. Concrete into place, with the
electrical service cable fed up through the middle of the base.

Remove and retain the four fixing bolts from the bottom of the outer pedestal skins. Ease the
skins out from the base of the unit to gain access to the interior, taking care not to damage or
put strain on the cable connectors.

Cut a neat hole in the supplied rubber splash mat to facilitate the electrical cable and fit over the
four studs of the ground mounting base

Carefully lift the pedestal and fit the chassis onto the ground mounting base, aligning the four
holes in the chassis with the four studs of the base

Feed the electrical cable up through the chassis base plate

Secure the chassis to the ground mounting base with the supplied nuts and washers
3. If a base is not supplied:

Prepare a suitable area of flat ground with a means of fixing the chassis of the pedestal to the
ground

Remove and retain the four fixing bolts from the bottom of the outer pedestal skins. Ease the
skins out from the base of the unit to gain access to the interior, taking care not to damage or
put strain on the cable connectors

Cut a neat hole in the supplied rubber splash mat to facilitate the electrical cable and fit over the
cable.

Carefully lift the pedestal and secure in place with suitable fastenings

Feed the electrical cable up through the chassis base plate
4. Terminate the supply cable in the appropriate manner and connect to the pedestal Live, Neutral and
Earth terminals.
5. Switch on the two overload/fault current devices (main power & LED lamp).
6. Refit the outer pedestal skins by inserting them in the channel in the divide located under the lens and
then feeding them into the extrusion running down the side of the chassis. Refit the four securing
bolts.
7. Switch on the power to the unit and test in accordance with current regional electrical regulations.
EV: BASICCHARGE
PEDESTAL
Doc No.: EVBAI-001 Rev: 01