Cartridge Temperature Adjustment - Aqualisa SIERRA Installation And User Manual

CARTRIDGE TEMPERATURE ADJUSTMENT

This product has been factory set under balanced pressures, and a hot
water supply of 65°C.
N.B. This product can reach temperatures in excess of 50°C.
If site conditions vary significantly from the factory conditions, it may be
necessary to reset the temperature of the cartridge to enable the product
to deliver 38°C when the temperature knob is set to the 38°C position.
In this case, you can adjust the cartridge to change the outlet water
temperature to suit your requirements. This can be adjusted whilst using a
digital thermometer and following the below instructions.
Turn the temperature knob to the 38°C position.
1.
Carefully remove the cap, loosen the screw, then remove the
2.
temperature knob.
Run the shower at required flow.
3.
Whilst measuring the temperature of the water, and without removing
4.
the temperature override stop, turn the brass spindle until the
temperature reaches 38°C.
Once 38°C is achieved, turn the shower off.
5.
Refit the temperature knob by depressing the temperature override
6.
safety button and carefully pushing the knob into place with the button
at the 12 o'clock position. Tighten the screw and fit the cap.
10
Thermostatic Valve
Override Button
Temperature
Override Stop
Temperature Knob
Screw
Cap