Toro 03240 Installation Instructions Manual page 8

Figure 13
1. Adjusting bolt
2. Locknut
3. Carriage bolt and flange
locknut (3/8 with 5/8 inch
hex)
5. Tighten the locknut on the HOC adjuster bolt,
then back off the locknut 1/2 turn
6. Center the front roller between the HOC bracket
assemblies and lock it in place with the cap
screws and flange nuts
g192299
4. Flange nut
5. Cap screw
(Figure 13).
(Figure 13).
8
Installing the Groomer
Drive Cap
Parts needed for this procedure:
3 Cap
Procedure
Only for Universal Groomer assemblies with no
rear roller brush kit installed:
1. Apply medium-strength cylindrical bonding
retaining compound (such as Green Loctite
609®) around the snap ring groove and the
outer diameter surface
2. Install the cap as shown in
1. Cap
8
(Figure 14).
Figure 14.
Figure 14
2. Apply medium-strength
bonding compound
g242099